README 1.43 KB
Newer Older
1
This is radsecproxy 1.4 from June 12 2010.
venaas's avatar
venaas committed
2

3
4
5
radsecproxy is a generic RADIUS proxy that supports both UDP and TLS
(RadSec) RADIUS transports.  There is also experimental support for
TCP and DTLS.
venaas's avatar
venaas committed
6

7
It should build on most Linux and BSD platforms by simply typing
8
9
10
11
12
13
14
15
"./configure && make".  It is possible to specify which RADIUS
transport the build should support.  Without any special options to
configure, all transports supported by the system will be enabled.
See the output from "configure --help" for how to change this.

To use radsecproxy you need to create a config file which normally is
called "/etc/radsecproxy.conf".  You can also specify the location
with the "-c" command line option (see below).  For further
16
17
instructions, please see the enclosed example file and the
documentation at
venaas's avatar
venaas committed
18
http://software.uninett.no/radsecproxy/?page=documentation
venaas's avatar
venaas committed
19

20
21
There are five options that may be specified on the command line:
"-c configfile" to specify a non-default config file path.
22
"-d loglevel" to set a loglevel of 1, 2, 3, 4 and 5 where 5 is the
23
24
25
26
27
              most detailed.
"-f" to run the proxy in the foreground with logging to stderr.
     Without "-f" the default is to detach as a daemon and log to
     syslog.
"-v" just prints version information and exits.
venaas's avatar
venaas committed
28
"-p" (pretend) makes the proxy go through the configuration files as
29
30
     normal, but stops before creating any sockets or doing any
     serious work.  This is useful for validating config files.